That other one should still be ok as listed in the doc's:
LineType (Line Type): Number: 0x1601
Description: The LineType parameter defines the physical line type (T1 or E1) and the framing format (for example, D4 or ESF). Framing formats include:
D4 framing (D4): For T1 lines, in D4 framing, 12 frames of 193 bits each (2,316 bits total) constitute a superframe. This framing format supports AB signaling.
Extended superframe (ESF): For T1 lines, in ESF framing, 24 frames of 193 bits each (4,632 bits total) constitute an extended superframe. This framing format supports ABCD signaling.
CEPT E1 :For E1 lines, uses CEPT E1 framing.
Cyclic redundancy check 4 (CRC-4) multi-frame: For E1 lines, this provides for CRC error detection. In this framing format, E1 lines have an extra framing that can coexist with the standard framing and the time slot 16 signaling framing. This extra framing is used to compute and check CRC-4 on incoming lines, to detect remote CRC-4 alarms, and to notify the remote line of CRC-4 errors. When CRC-4 framing is enabled, all CRC-related statistics will be collected and reported, and the RAI_CRC_CFA alarm will be detected and reported.
Analog: Analog is the framing used for Dialogic Integrated Series boards.
Values:
• 0: T1 D4 (dsx1_D4)
• 1: T1 ESF (dsx1_ESF)
• 2: E1 CEPT E1 (dsx1_E1)
• 3: E1 CRC 4 multi-frame (dsx1_E1_CRC)
• 4: analog
Just didn't get added in the config file from the generator I suppose. Thus using 2 is still valid.
Jeff